XCP is a common requirement from automotive OEMs. I’ve found that Implementing XCP-on-CAN for a C2000 device is far from straightforward and there doesn’t seem to be much information publicly ...

I wondered which parameters I can change (except parameters of my motor) during my own tuning process when using hvkit with F28069M ISO Control Card? When I was ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask ...

We are building the Ti Yocto Linux but everytime it gives an error in the following package, gdk-pixbuf_2.42.10. This is the command that we use for the setup: ./oe ...

I have a pretty large multi-core program for the TMS320C6678L which I want to run on several cores. Because the program is so large I must load it on the DDR3 ram. I split up the program using the ...

Texas Instruments (TI) Bluetooth® support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search Bluetooth® IC content or ...

My customer is using the LMK04828 for below evaluation scenario: The S1 and S2 are from the signal generator and the same phase sine-wave signal, when testing, both LMK04828 EVMs are set at 0-delay ...

In my application, I need to determine if the watchdog is enabled and running. I went through the datasheet and it seems there is no "status" information. The only way how to determine if it is ...

I have recently bought a laptop from Lenovo ( Legion gen8 16IRX8H ) , that does not have sound support among Linux users. This smart amplifier is a TAS2781 which ...

In the registers section of the GPIO chapter of SPRUI33A (TRM), it states that GPyMUX must be setup before GPyGMUX (e.g. for GPAMUX1 in section 8.7.1.1.4 “Pins must be set to GPIO mode using this ...

The description of ResRelax Time in the technical documentation is as follows. ResRelax Time is the time constant of the battery's transient response, which represents the time it takes for the ...